材料科学の英語論文で頻出の英単語 36 語

材料科学の論文では、phase・grain・defect のような短い語が、結晶や組織の決まった概念を指します。作製と熱処理の語(anneal、sinter、quench)や、強さを表す語(strength、hardness、toughness)の違いを押さえると、実験の節と結果の図が読みやすくなります。

各語に、品詞、材料科学の論文での意味、一般的な意味との違い(ある場合)、例文を載せています。例文は説明のために作った文で、実在の論文からの引用ではありません。

A

aging名詞
時効。溶体化処理と急冷の後に一定の温度で保ち、析出などによって性質を変えること。
一般の意味との違い一般には「老化、加齢」。
Peak hardness was reached after aging at 180 °C for 8 h.
alloy名詞
合金。金属に、ほかの元素を加えたもの。
The high-entropy alloy showed excellent strength at cryogenic temperatures.
amorphous形容詞
非晶質の、アモルファスの。原子の並びに長い距離の規則性がない。
The as-deposited film was amorphous and crystallized upon annealing at 600 °C.
anneal動詞
焼なましする、アニールする。加熱して一定時間保ち、ひずみを取ったり組織を整えたりする。
一般の意味との違い分子生物学では、DNA の相補鎖が結合する「アニーリング」を指す。
The films were annealed at 500 °C for 1 h in nitrogen.

B

brittle形容詞
脆い、脆性の。ほとんど塑性変形せずに破壊する。
The intermetallic layer is brittle and cracks under small strains.
bulk名詞
バルク。表面や界面に対して、材料の内部。薄膜やナノ粒子に対して、塊状の材料を指すこともある。
一般の意味との違い一般には「大部分、かさ」。
The surface layer has a lower oxygen content than the bulk.

C

composite名詞
複合材料。性質の異なる材料を組み合わせたもの(炭素繊維強化プラスチックなど)。
一般の意味との違い一般には形容詞「合成の、複合の」。
The composite retained 90% of its flexural strength after thermal cycling.
corrosion名詞
腐食。周りの環境との化学反応・電気化学反応によって、材料が劣化すること。
Pitting corrosion was observed after 500 h of salt spray exposure.

D

defect名詞
欠陥。結晶の規則的な原子の並びの乱れ(点欠陥・線欠陥・面欠陥)。
一般の意味との違い一般には「欠点、不良」。材料では、性質を制御するために意図して導入することもある。
Oxygen vacancies are the dominant point defects in the film.
deposit動詞
成膜する、堆積させる。基板の上に薄い層を作る。
一般の意味との違い一般には「預ける、置く」。
A 50-nm Al₂O₃ layer was deposited by atomic layer deposition.
diffraction名詞
回折。X 線などの波が結晶で散乱して干渉し、特定の方向に強く出ること。結晶構造の同定に使う(X 線回折、XRD)。
X-ray diffraction patterns showed only the peaks of the perovskite phase.
dislocation名詞
転位。結晶の中の線状の欠陥。転位が動くことで塑性変形が起こる。
一般の意味との違い一般には「(関節の)脱臼、混乱」。
High dislocation densities were observed beneath the indent.
dopant名詞
ドーパント。性質を変えるために、少量加える不純物元素。
Nb was introduced as a donor dopant to increase conductivity.

E

elongation名詞
伸び。引張試験で、破断するまでに伸びた割合。延性の指標。
The alloy exhibited a tensile strength of 1.2 GPa and an elongation of 15%.
embrittlement名詞
脆化(ぜいか)。水素や照射などによって、材料がもろくなること。
Hydrogen embrittlement reduced the elongation to failure by half.
epitaxial形容詞
エピタキシャルな。基板の結晶の向きにそろって、結晶が成長した。
X-ray diffraction confirmed the epitaxial growth of the film on the SrTiO₃ substrate.

G

grain名詞
結晶粒。多結晶の材料を構成する、結晶の向きがそろった小さな領域。
一般の意味との違い一般には「穀物、粒」。木材では「木目」。
The average grain size decreased from 25 μm to 3 μm after severe plastic deformation.
grain boundary名詞句
粒界。隣り合う結晶粒の境目。
Segregation of impurities at grain boundaries caused embrittlement.

H

hardness名詞
硬さ。押し込みや引っかきに対する抵抗(ビッカース硬さなど)。強度や剛性とは別の指標。
Vickers hardness increased from 180 HV to 320 HV after aging.

L

lattice constant名詞句
格子定数。結晶の単位格子の辺の長さ。
The lattice constant increased linearly with Ga content, following Vegard's law.

M

matrix名詞
母相、マトリックス。合金や複合材料で、析出物や強化材を取り囲む主な部分。
一般の意味との違い数学では「行列」。
Carbon fibers were embedded in an epoxy matrix.
microstructure名詞
微細組織、ミクロ組織。顕微鏡で見える結晶粒・相・析出物などの組み合わせ。
The microstructure consisted of equiaxed ferrite and dispersed pearlite.

P

passivation名詞
不動態化。表面に薄い酸化皮膜ができて、腐食が進みにくくなること。半導体では、表面の欠陥を不活性にする処理を指す。
Chromium promotes the passivation of stainless steel.
phase名詞
相。化学組成と構造が均一で、境界でほかと区別できる部分(α 相、液相など)。
一般の意味との違い一般には「段階、局面」。
A secondary phase rich in Cr precipitated at the grain boundaries.
phase diagram名詞句
状態図、相図。温度や組成に応じて、どの相が安定かを示した図。
According to the binary phase diagram, the alloy is single-phase above 900 °C.
porosity名詞
気孔率。材料の体積に占める、すき間(気孔)の割合。
The porosity decreased from 12% to 2% with increasing sintering temperature.
precipitate名詞
析出物。母相の中に新たに生じた、別の相の微細な粒子。
一般の意味との違い化学の溶液では「沈殿(物)」。
Nanoscale precipitates impede dislocation motion and raise the yield strength.

Q

quench動詞
急冷する、焼入れする。高温から水や油に入れて、急速に冷やす。
一般の意味との違い化学の論文では「反応を止める」。一般には「(渇きを)いやす、(火を)消す」。
The samples were solution-treated at 1,050 °C and quenched in water.

S

sinter動詞
焼結する。粉末を融点より低い温度で加熱し、粒子どうしを結合させて固める。
The powders were sintered at 1,400 °C to a relative density of 98%.
substrate名詞
基板。薄膜などを成長・堆積させる土台の材料。
一般の意味との違い生化学では「基質」。
Lattice mismatch between the film and the substrate induced compressive strain.

T

tensile形容詞
引張の。
Uniaxial tensile tests were performed at a strain rate of 10⁻³ s⁻¹.
texture名詞
集合組織。多結晶の中で、結晶粒の向きが特定の方向にそろっていること。
一般の意味との違い一般には「手触り、質感」。
Rolling produced a strong {111} texture in the sheet.
thin film名詞句
薄膜。基板の上に作った、厚さがナノメートルからマイクロメートルの層。
Thin films were deposited on Si substrates by RF sputtering.
toughness名詞
靭性(じんせい)。き裂が進むことや破壊に抵抗し、エネルギーを吸収する能力。破壊靭性(fracture toughness)で表す。
一般の意味との違い一般には「たくましさ、頑丈さ」。硬さや強度とは別の性質。
The fracture toughness of the ceramic was improved by adding zirconia particles.

V

vacancy名詞
空孔。結晶の中で、本来は原子があるべき位置が空いている点欠陥。
一般の意味との違い一般には「空室、欠員」。
Vacancy diffusion controls the sintering rate at this temperature.

Y

yield strength名詞句
降伏強さ、耐力。塑性変形が始まる応力。降伏点がはっきりしない材料では 0.2% 耐力を使う。
The yield strength followed the Hall–Petch relationship with grain size.

読んでいる論文から、自分の辞書を作る。

Goipon では、材料科学の論文の PDF を開いて、引っかかった単語をタップするだけで、その一文での意味と出典がそろったカードができます。ここにない単語も、自分が読んだ文で覚えられます。

この分野の論文を Goipon で読む

辞書 100 語まで無料。クレジットカードの登録は不要です。